If cable is pinched it canĬause immediate short and wires can get hot, melt plastic, and create a fire hazard.FSC 6230 Electric Portable and Hand Lighting Equipment MFG SKU Note: When disconnecting plugs, grasp the plug body itself never pull on cord.ĬAUTION: Make sure cable cannot be pinched. Attach end of DC power cord or AC converter to charging cradle by inserting round plug into power connection port in the side of the charging cradle. Locate and mount the cradle using appropriate screw and anchors for the location and material.Ģ. The red (positive) lead is connected to the fuse output, and the black (negative) ground wire should be attached to a metal part of the chassis, which serves as a battery ground return.ġ. This is most often the radio or accessory fuse.
Mag Instrument recommends using only an ignition-switched (fused) circuit, and preferably the lowest output available (5 amps or less). Note: For maximum protection of recharging unit, it is recommended that a 1-amp fuse be installed in the (+) red lead.ĭirect Wire–Vehicle Installation 12–14 Volt Only (Not for 24-Volt Systems)Ī 4’ power accessory cord is available to facilitate the direct-wiring of the rechargeable system (Fig. Doing so creates excessive heat and may result in a fire or melted components. Note: All electrical components are designed for 12–14 volt DC circuits. Input can be from 12–14 volts (automotive installations) or 120-240 volts AC, when used with a converter for charging indoors.
Once it is mounted to a wall or in a vehicle, you’ll find that the technique for removing and returning the flashlight to the Charging Cradle works with one motion.Ĭonstructed of engineering grade thermoplastics, this Charging Cradle unit has many features. Apply downward pressure on the barrel portion of the light until the light snaps into place. Hold the Charging Cradle and front of light with one hand. Place the front end of the light into the front end of Charging Cradle with a slight angle. Returning the flashlight into the Charging Cradle requires the following steps: (Fig. A firm downward pressure with the thumb on cradle while pulling up on the barrel with the other four fingers will quickly snap it free. Holding the Charging Cradle firmly in one hand (Fig. 3) remove the flashlight by following these steps:ġ. If you have received your system with the flashlight mounted in the Charging Cradle (Fig.
0 kommentar(er)
